What is the specific steps loadometer disassembly
　　很多的公司在完成一项项目以后，地磅都要进行地磅维修搬家，那么地磅就要被拆卸下来，下面就给大家介绍一下地磅搬迁的全过程。
　　Many of the company after the completion of a project, must be loadometer loadometerloadometer repair move, then can be disassembled, here to introduce the whole process ofloadometer relocation.
　　首先要准备好工具，要用到五吨以上的千斤顶一个，还要有螺丝刀，还有24套筒和套筒的扳手，还需要一个相对应的螺丝内六角。先使用活动的扳手把地榜的螺丝打开，然后把每一个盖板都拆开，在地磅中间位置有一个小的盖板，然后取出里面的接线盒，打开接线盒以后，然后把传感器还有主线从接线盒中都拿出来，并且要做好相应的记录。如果地磅是两节以上的，那么要把每两节的传感器进行拆除，把上面的螺丝拧下来。然后用六角的活动扳手把横向的螺丝拧开，如果拧的力量不够可以使用套筒。
　　First of all to ready to use tools, Jack of more than five tons of a, also with a screwdriver, and 24 sleeve and the sleeve wrench, also requires a corresponding screw inner six angle.Wrench to use activity to list the screw to open, and then each cover is opened, there is a small plate in the middle position loadometer, then remove the junction box inside, then open the junction box, and then the sensor and the thread out from the connection box, and to do a good job in the corresponding records. If the scale is more than two, then how should thesensor sections were removed, turn the screw top down. Then use the wrench six angleunscrew the horizontal screw, if not the power of using the socket.
　　最后就是仔细的检查一遍看看是不是全部的固定件都拆除了，不要破坏原件，否则还得进行地磅维修，收拾好这一些，可以从地磅房中把主线抽出来了。
　　The last is to carefully check all have a look Is it right? Fixed parts are removed, do not destroy the original, otherwise have to weigh up the repair, some, can put the thread out fromloadometer room.